So I’ve been interested in impro-guns for a while and came up with some patents for gun mechanisms and designs that are so crude that anybody with even the most basic of knowledge of guns would be able to understand. In California and Europe, many gangs are making guns, but the most disarmed group of people are the average population. Only a very tiny amount of Europeans (outside of Switzerland) even own a gun, thanks to their governments. So what I’ve decided to do is come up with a few designs and see what you guys think of them.
>a .32 ACP semi-automatic pistol that’s modeled after pic related (Ruger MK IV), but with a nail gun that’s small and compact enough to fit inside the mag well to act as both the striker and to attach your trigger into through a small hole in the frame/nail gun with a flat, sturdy metal rod that’s silver (the desired gun I have in mind is all silver) that’s bent downwards at the front end with a semicircular groove going upwards to provide the trigger grip, with the trigger action being a backward pull into the hole in the nail gun that connects to the inner trigger mechanism which will shoot a nail into the primer of each bullet, with the action of the extractor slide going upwards, as a backwards action could result in the nail becoming shrapnel to the shooter, and also so that the nail and spent cartridge casing will be projected downwards, falling to the ground after each shot.
>a .22 BB/CB (possibly .22 short?) semi-automatic pistol made out of a staple gun, that is made by soldering a screw in front of the metal plate housed within the top of the staple gun that pushes each staple through the hole in front (the staple gun should be metal, preferably silver in color) to serve as the firing pin, tightening the springs and pins so much to where the trigger on the back when pushes barely moves more than an inch, as that should be enough to strengthen to snap into the forward action so that you don’t have to push it all the way in with each shot and still have a comfortable, steady grip around the trigger/frame, and loaded with a thin tubular magazine that’s small enough to fit inside the metal slot where you insert the staples in (this is why I’d recommend using .22 BB/CB ammunition), and attaching a barrel through the hole after widening it enough so that it fits and the barrel is chambered for the right kind of ammunition you’re using, and since the part where the staples come in and out are so close, you should have no problems with chambering each round.
>a simple flamethrower made out of a caulking gun. Use an aerosol can spray, take off the plastic cap so that you only have the needle nozzle, place it in there, tighten the plunger to the rear of the van, push it up tightly to the front, take a piece off a wire coat hanger with an elbow shape bent into it and attach it to the frame of your caulking gun with either electric tape or perhaps a hose clamp, attach a cotton candle wick to the coat hanger piece that will hold the flame (because they burn slower), and then light the wick and pull the trigger to shoot the flame (NOTE: I’d recommend using anything with paraffin in it since that shit is highly flammable and should give you a pretty healthy sized flame, also I’d advise against using matches since they’re unpredictable, and if you have a spool of it, you could tie the cotton candle wick around the metal wire piece instead of taping it).
Any other ideas?